Leading 10 usual forklift crashes ， forklift procedure need to pay attention to these issues ！.
Leading 10 usual forklift crashes ， forklift procedure need to pay attention to these issues ！.
Blog Article
Do not take too lightly the forklift at work. If the operation is not good, there will be severe crashes in mins, and there are several accidents involving forklifts.
Case 1: The forklift cargo blocked the driver's sight, and the person in front could not be found, resulting in a moving crash.
Instance 2: In order to keep the equilibrium of the forklift when raising hefty products, the workers used their body weight as the counterweight, which almost caused casualties.
Instance 3: The size of the forklift freight surpasses the permitted width of the route and holds on the roadside rack, which nearly triggers an accident.
Case 4: Forklift is speeding up and surrender during a turn.
Case 5: The forklift driver did not see the pedestrian, and the pedestrian did not see the forklift.
Situation 6: The forklift lifts the personnel unlawfully, the forklift motorist does not wear the seat belt, the forklift lifter drops and the chauffeur is crushed when the forklift surrender.
Situation 7: The forklift driver did not put on a seat belt and fell from the lorry when it rolled over and was crushed.
Forklift procedure ought to take note of these issues ：.
Beginning.
1. Before beginning, observe the surroundings, and after confirming that there are no challenges that hinder the safety and security of driving, honk the horn first and after that start.
2. For lorries with hydraulic (air pressure) brakes, the brake hydraulic stress (air pressure) scale must be secure before beginning.
3. When the forklift starts with a tons, the driver needs to first validate that the load is secure and reputable.
4. The start needs to be slow-moving and stable.
Driving.
1. When driving, the elevation between the bottom end of the fork and the ground must be kept at 300mm-400mm, and the mast needs to be slanted in reverse. .
2. Do not lift the fork expensive when driving. When entering and leaving the task website or while driving, take care that there will be no challenges overhead. When the load is taking a trip, the fork has to not be raised expensive, which will certainly affect the stability of the forklift. .
3. After dumping, the fork should be reduced to the normal driving placement prior to driving. .
4. When turning, if there are pedestrians or lorries nearby, the driving signal should be released first. High-speed doglegs are banned. High-speed doglegs will trigger the vehicle to shed lateral stability and topple. .
5. When the forklift is downhill, it is strictly restricted to shut off the fire and slide, and it is restricted to brake suddenly while driving with tons unless there are unique situations.
6. When the forklift is running, it has to follow the website traffic rules in the manufacturing facility and must keep a certain security range from the vehicle in front. .
7. When the forklift is running, the lots must be in the lowest placement that does not prevent the driving, and the gantry ought to be properly tilted back. The tons shall not be elevated other than when piling or filling. .
8. The elevation of the tons need to not block the chauffeur's view. In unique scenarios, when the product impacts the forward vision, drive at a low speed when reversing.
9. It is forbidden to activate the ramp, neither to drive across the ramp. .
10. The risk-free driving speed of the forklift in the manufacturing facility location is 5 km/h, and it needs to drive safely at a low rate when getting in the manufacturing workshop area. .
11. When the forklift is lifted, raised or driven, it is prohibited for workers to stand on the fork to hold things and play a stabilizing function. .
12. If problems are located, they will certainly be repaired and reported in a prompt fashion, and they will never run with ailments or conceal them.
loading and dumping.
1. When fork-loading products, the distance between both forks should be adjusted as required to make the lots of both forks balanced and not manipulated, and one side of the item need to protest the rack. .
2. It is restricted to collaborate with a solitary fork or use a fork top or draw. In special situations, safety indication have to be set up to advise surrounding pedestrians. .
3. In the process of loading and unloading things, the forklift must be stopped with the brake. .
4. The rate of the car ought to be sluggish and constant. Be careful not to roll the wheels on the dunnage, so as not to stretch the rolled things and harm people. .
5. When making use of a fork to fork the Stand-on Electric Pallet Stacker goods, the fork must be as deep as feasible under the tons, and it needs to be noted that the fork suggestion should not touch other goods or things. The load ought to be maintained with minimal back tilt of the gantry to make sure that the load does not glide in reverse. The mast can be slanted onward slightly when the load is decreased to permit very easy positioning of the lots and extraction of the forks. .
6. It is forbidden to fork items Stand-on Electric Pallet Stacker at broadband and ram tough things with the fork head. .
7. When the forklift is functioning, it is prohibited for individuals to stand around the fork, so as to avoid the collapse of the goods and injure individuals. .
8. Overwhelming is forbidden, and it is restricted to utilize forks to lift personnel to participate in high-altitude procedures to prevent high-altitude falling mishaps. .
9. It is not permitted to make use of the brake inertia to slide, place, round or roll things. .
10. It is not enabled to use forks to select, transform pallet discharge.
Leaving .
1. It is prohibited to leave the forklift when the items on the fork are in the air. Before leaving the forklift, you need to discharge the goods or lower the fork frame.
2. Pull the hand brake take care of to dead or depress the emergency brake switch.
3. The engine is switched off and the power is cut off. (Except for unique scenarios, such as the motorist does not leave the car's line of sight and does not go beyond 1 min).
4. Remove the key. .
Forklift Operation Precautions.
1. Prior to and after the forklift operation, the look should be checked, and gas, lubricating oil and cooling water need to be added.
2. Examine the safety efficiency of starting, running and braking.
3. Check whether the lights and horn signals are full and effective.
4. During the procedure of the forklift, check whether the pressure and temperature are normal.
5. After the forklift is running, the external leakage must also be examined and the seals need to be changed in time.
Forklift Safety Operation Specifications.
1. You should inspect before leaving the automobile;.
2. When you encounter somebody before you during driving, you should send out a signal at a distance of 5 m;.
3. The driving speed in the factory does not go beyond 5 km/h;.
4. When driving, the low point of the freight need to be 0.3 m ~ 0.4 m in the air;.
5. The transforming must not be as well sharp to avoid the tendency of " cost-free switching";.
6. Running up and down the incline needs to be slow-moving and consistent, and no switching on the slope is allowed.
7. Do not drive throughout the slope. When the slope is higher than 10%, the lorry ought to be driven backwards when declining;.
8. When the forklift personnel bring the goods and progress, if they encounter big or heavy items and go to the vehicle driver's line of vision, they need to take the turning around workout
.
The "Eight Prohibitions" ought to be complied with in the operation.
1. Single fork procedure is not permitted.
2. It is not enabled to lift the goods for cross country driving.
3. It is not enabled to get the goods by handing over the pallet with the fork.
4. It is not permitted to directly shovel chemicals, flammables and other harmful chemicals with forks.
5. It is not allowed to utilize inertia pressure to get the goods.
6. It is not enabled to utilize stopping pressure to expatriation round or easy-to-roll objects.
7. It is not allowed to bring individuals to deal with the pallet or fork, and it is purely prohibited to stand under the fork after the fork is increased.
8. Do not drive side to side on slopes
.
Auto parking is not allowed under the list below problems.
1. Curves, slim roads, train crossings;.
2. Areas with a longitudinal incline greater than 5%.
3. When there is an challenge on one side of the roadway, the opposite side of the area with the same length as the challenge must be within 20 meters at each end.
Web：https://www.onenforklifts.com/
Email：info2@onen.cn
Phone：+86 13827083844